DreamPort Sleep Solution CPAP Starter Kit Features
- Completely Without Headgear
- Easy to Use DreamPort Adhesive Nose Covers
- Intuitive Design Fits All
- Extremely Lightweight
- Ergonomic Short Tube Design
- Hypoallergenic and Latex-Free
- No Headgear Means No Red Marks or Messy Hair
- Whisper Quiet - 26 decibels
Kit Includes:
- Bleep DreamWay Interface with 10 inch hose and connector
- Bleep DreamPorts (32-Pack, 16-Night Supply)
- Instruction Guide
How To Use BleepSleep DreamPort CPAP?
Applying the DreamPort Nostril Covers Follow these steps given below:
- Remove the DreamPort Nostril Covers from the pad. User will need 2 each night.
- Tilt head back to see nostrils clearly.
- Carefully line up and center the DreamPort so it can function as an extension of nostrils. Avoid placing over the cartilage of the nose, as this can disrupt airflow.
- Follow the same steps when applying the DreamPort to other nostril.
- If user is not able to breathe well, They may need to adjust the DreamPorts so it can line up correctly.
- The airflow may be partially covered by tape.
- Adjust the DreamPort as needed until user able to breathe easily.
Connecting the DreamPorts to the DreamWay interface:
- It's best to connect one node at a time. Begin by pinching the quick release tip of the connector, located on the side of the mask connector.
- Guide the node into place so that it pairs with the tube found on the DreamPort. Let go of the clips. User should hear an audible click.
- Repeat the process for the other nostril. Once user connect both nodes to its tube counterpart, mask is ready for use.
- Connecting the short tube to user standard size hose.
- To connect the short tube to the hose, user will need to guide the open end of the hose to the open end of the short tube and slide the short tube into place.
Note: This product is NOT compatible with the AirMini.
